Minuteman-ups MMS-CAT5-LAN-RJ45 Manuel d'utilisateur télécharger pdf

A. LineGuard CAT 5 Modules (Models:

MMS-CAT5-LAN-RJ45, MMS-CAT5-POE-

RJ45). See Figure 1.

These models protect one 8-wire Cat 5 cable

using RJ45 connectors.

1. Simply plug the RJ45 jack from the line input

cable into the “Line” side of the LineGuard

unit.

2. Using a Cat 5 (or better) patchcord, plug

one end into the “Equipment” side of the

LineGuard unit and the other side of the

patchcord into the equipment to be

protected.

3. Mount the LineGuard unit to a solid surface,

like plywood. Drill a 3/32 hole for the #6 x

3/4 screw and eyelets provided. See figure

3. Attach the screw and the eyelet to the

wall and slide the LineGuard unit over screw

and tighten. Add a second screw to bottom

of the LineGuard unit.

NOTE: If the LineGuard is to be used as a

stand-alone unit, connect a minimum #14 AWG

wire from the ground terminal tab to common

earth ground with 1 ohm or less (0.5 ohms

preferred). Use a single ground for the

LineGuard unit and the protected equipment to

eliminate differences in ground potential.

Additional LineGuard units may also be bonded

together as shown in figure 4 below (dotted

outline).

B. LineGuard CAT 6 Modules (Models:

MMS-CAT6-LAN, MMS-CAT5-POE). See

Figure 2.

These models protect one 8-wire Cat 6 cable

using 110 connectors.

1. Remove the LineGuard unit’s cover.

2. Strip off 1.5" of the jacket from line input 24

AWG OSP cable and the protected

equipment cable.

3. Insert the OSP cable (“LINE” side) into the

clip on the printed circuit board. If a shielded

cable is used, connect the shield to the clip.

4. Punch down the line input pairs on the 110

connectors (“LINE” side) carefully

maintaining proper wire twist.

NOTE: The color code is printed on the PC

board next to the connector.

5. Punch down the protected equipment pairs

on the opposite 110 connectors

(“EQUIPMENT” side) carefully maintaining

proper wire twist.

NOTE: The color code is printed on the PC

board next to the connector.

6. Position and tightly secure a cable tie on

each cable to provide strain relief next to

cable exit holes in the LineGuard unit’s

housing.

7. Replace the cover.

8. Mount LineGuard unit to a solid surface, like

plywood. Drill a 3/32 hole for the #6 x 3/4

screw and eyelets provided. See figure 4.

Attach the screw and the eyelet to wall and

slide the LineGuard unit over screw and

tighten. Add a second screw to the bottom

of the LineGuard unit.

9. When used as a Primary Surge Suppressor,

connect the grounding strip to a good earth

ground with a minimum 10 AWG wire. Use

the ring lug and the machine screw

provided. Route wire as direct and as short

as possible. For Isolated Loop applications,

connect to a single point ground with a

minimum 14 AWG wire as shown in figure 4.

10. Additional LineGuard units may also be

bonded together as shown in figure 4

(dotted outline).

LineGuard POE Surge Suppressor Wiring

Conventions:

• Shall be wired per TIA/EIA 568A or 568B.

• Power Pairs: Blue, Brown (Clamp at 62V).

• Data Pairs: Orange, Green (Clamp at 16V).

C. Start Up.

After the LineGuard unit has been properly

installed and connected, turn on the power to

the LineGuard unit and then the protected

equipment. The installation is complete.

MINUTEMAN UPS

1455 LeMay Dr.

Carrollton, TX 75007

Phone: (972) 446-7363

Fax: (972) 446-9011

www.minutemanups.com

1 2

MINUTEMAN UPS 1

Résumé du contenu

Page 1 - MINUTEMAN UPS

A. LineGuard CAT 5 Modules (Models: MMS-CAT5-LAN-RJ45, MMS-CAT5-POE-RJ45). See Figure 1. These models protect one 8-wire Cat 5 cable

Page 2

LIMITED WARRANTY AND CONNECTED EQUIPMENT GUARANTEE By purchasing a MINUTEMAN LineGuard Surge Suppressor in the United States or Canada, the original e

Modèles reliés MMS-CAT5-POE- RJ45

Commentaires sur ces manuels

Pas de commentaire

Minuteman-ups MMS-CAT5-LAN-RJ45 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour ordinateurs Minuteman-ups MMS-CAT5-LAN-RJ45. Minuteman UPS MMS-CAT5-LAN-RJ45 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés MMS-CAT5-POE- RJ45

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Minuteman-ups MMS-CAT5-LAN-RJ45